Ceramic Tiled Bathroom Refreshed in Wilmslow

This Ceramic tiled bathroom with shower was installed at house Wilmslow and was overdue a refresh. You can see from the photographs below that the bathroom was looking tired and the tile and grout was discoloured with mould and acid build-up from washing products.

Ceramic Bathroom Tiles Wilmslow Before Ceramic Bathroom Tiles Wilmslow Before

Cleaning Ceramic Tile and Grout

The Ceramic tiles and grout were treated using a strong 2:1 dilution of Tile Doctor Pro-Clean which is a strong alkaline Tile and Grout cleaning product. The solution was decanted into a bottle with a trigger spray attachment which when sprayed onto the wall allows the cleaner to mix with air making it lighter and allowing it to stick better. The solution was then worked in using a stiff scrubbing brush by hand before being rinsed off with water; this process was repeated a number of times until we had managed to clean all the areas and then left to dry.

Grout Colouring

The grout looked better but I was unable to shift some of the staining so we decided to apply a white Grout Colourant, it’s a time consuming process but I think you will agree it made a big difference. Additionally the grout colourant product we use also forms a barrier over the surface making the grout much easier to clean going forward.

The last step was to remove the silicone sealant from along the top of bath and replace with new.

Ceramic Bathroom Tiles Wilmslow After Ceramic Bathroom Tiles Wilmslow After

 
 

Refreshing a Ceramic Tiled Bathroom Wilmslow

Stained Victorian Tiles restored in Kingswood, Cheshire

This classic Victorian tiled floor in Kingswood Kitchen; Cheshire was quite dirty and in need of a deep clean. Cleaning this type of floor is bread and butter for a Tile Doctor and so I had every confidence we could clean in and then re-seal it without any complications.

Victorian Floor Kingswood Before Cleaning 006 Victorian Floor Kingswood Before Cleaning 005

Cleaning a Stained Victorian Floor

In order to tack the ingrained dirt and I decided the best course of action would be to cover the Victorian Floor tiles with a 50/50 mix of Tile Doctor Pro-Clean and Nano-Tech UltraClean and leave it to work on the tile allowing the cleaner to break down any remaining previous sealer and in-grained dirt.

Victorian Floor Kingswood During Cleaning 007 Victorian Floor Kingswood During Cleaning 008

After about 30 minutes I steam cleaned the whole area multiple times to lift the ingrained dirt and grime out of the floor and then give the floor a thorough rinse removing the soiled solution using a wet vacuum. The floor was quite damp at this stage and needs to be dry to seal so we left it to dry overnight, we also left behind a dehumidifier to assist with the drying process.

Sealing a Victorian Floor

The next day we came back and tested the floor using a damp meter to make sure it was dry. Once we were satisfied we sealed the tiles using five coats of Tile Doctor Seal and Go which is ideal for Victorian tiles as it leaves an attractive low sheen finish, it’s also a water based sealer so there is no smell.

Victorian Floor Kingswood After Cleaning 012 Victorian Floor Kingswood After Cleaning 013

 
 

Soiled Victorian Tiled hallway floor cleaned and sealed in Cheshire